JET DRYER HEPA FILTER FOR HAND DRYER SMART Package contents: 1 piece

The HEPA Filter is designed for the Jet Dryer SMART hand dryer.

The certified HEPA filter is used to capture even the smallest dust particles.

The SMART hand dryer requires 2 pieces of HEPA filters for its operation!

Removing HEPA filters

You will find filters under the air intake grilles on the side of the dryer. Press the upper part of the grille with two fingers. You should hear a click and the grille will open. Simply remove the air filters from the side of the appliance. In case an air freshener block is attached to the filter with a securing clip, you must first remove the air freshener block and then remove the HEPA filter.

Cleaning HEPA filter

Rearranging the HEPA filter By tapping lightly or using a vacuum cleaner, remove the dirt, you can also use a soft brush. If the HEPA filter is heavily contaminated, it needs to be replaced.

!!! Do not rinse the filters with water !!!

Putting the HEPA filter back into the device

Insert the filter back into the plastic holder and secure it with a locking clip. If an air freshener was installed, place the air freshener block behind the filter and secure it with a locking clip.

First, put the bottom part of the holder back into the locking groove of the hairdryer.

After making sure that the bottom part of the holder is in the groove, snap the holder into the device and press firmly in both upper corners until you hear a click and the doors stay secured. Check if the holder is properly attached. Keep the holder's grid clean.

Note: package contains 1 piece of HEPA filter